| Saving Stabilizer Most people cut one piece of stabilizer at a time to fit their hoop to sew a design. After you have sewn the design then you end up with wasted stabilizer on each side of the hoop. |
 |
| I cut my stabilizer to fit the
"height" of my hoop and leave it the width of the
stabilizer. In this instance I was using vilene which is 58" wide. I just folded the excess stabilizer and pinned it on the left to keep it tidy and out of my way. |
 |
| After sewing my design, I just trimmed the stabilizer as shown above. |
 |
| You have saved a 2-3 inches of stabilizer on
the left side to start another design. Just unroll enough stabilizer to fit your hoop and you are ready to go! |